gefran GFX OP Manuel D'utilisation page 17

Programming terminal for Geflex (installation on DIN guide or on heatsink),
complete with connection cable to Geflex (L=0,2m)
Note: see cable section for other cable lengths
Programming terminal for Geflex (installation on faceplate)
Note: see cable section for connection cable
Kit consists of:
power supply, connection cable PC <--> GFX-OP-D (L=1,5 m),
power adapter for the Geflex
ACCESSORIES
Connection cable for GFX-OP <-> Geflex or for Geflex Slave <-> Geflex Slave
complete with connectors, length 1m
Connection cable for GFX-OP <-> Geflex or for Geflex Slave <-> Geflex Slave
ccomplete with connectors, length 2,5m
Connection cable for GFX-OP <-> Geflex or for Geflex Slave <-> Geflex Slave
complete with connectors, length 5m
Stabilized power supply (24 Vdc,12W) complete with power adapter for Geflex
3-terminal connector (J2) for Geflex Slave to an output
7-terminal connector (J1) for Geflex Master/Slave inputs/power supply
8-terminal connector (J2) for 3-output Geflex Master/Slave
!
WARNING: this symbol indicates danger.
Read the following warnings before installing, connecting or using the device:
• follow instructions precisely when connecting the device.
• the instrument must be used exclusively with the Geflex product as specified on the connection diagram.
• the device has no ON/OFF switch: it switches on immediately when power is turned on.
• if the device is used in applications where there is risk of injury to persons and/or damage to machines or materials, it MUST
be used with auxiliary alarm units. You should be able to check the correct operation of such units during normal operation of the
device.
• before using the device, the user must check that all device parameters are correctly set in order to avoid injury to persons
and/or damage to property.
• the device must NOT be used in inflammable or explosive environments. It may be connected to units operating in such envi-
ronments only by means of suitable interfaces in conformity to local safety regulations.
• the device contains components that are sensitive to static electrical discharges. Therefore, take appropriate precautions when
handling electronic circuit boards in order to prevent permanent damage to these components.
Read the warnings in the instruction manual regarding installation conditions for the Geflex device.
GEFRAN spa will not be held liable for any injury to persons and/or damage to property deriving from tampering, from
any incorrect or erroneous use, or from any use not conforming to the device specifications.
CE MARKING: EMC conformity (electromagnetic compatibility) with EEC Directive 89/336/CEE with reference to the generic
Standard CEI- EN61000-6-2 (immunity in industrial environments) and EN50081-1 (emission in residential environments).
BT (low voltage) conformity respecting the Directive 73/23/CEE modified by the Directive 93/68.
MAINTENANCE: Repairs must be done only by trained and specialized personnel.
Cut power to the device before accessing internal parts. Do not clean the case with hydrocarbon-based solvents (Petrol,
Trichlorethylene, etc.). Use of these solvents can reduce the mechanical reliability of the device. Use a cloth dampened in ethyl
alcohol or water to clean the external plastic case.
SERVICE: GEFRAN has a service department. The warranty excludes defects caused by any use not conforming to these
instructions.
ORDER CODE
• WARNINGS
17
GFX-OP-D
GFX-OP-P
GFX-OP-K
CV-1
CV-2
CV-5
PWS24
CSIG-3
CSIG-7
CSIG-8