Publicité
Setting the Automatic Mode
To Change the Automatic Mode settings
First press the Manual/Automatic select button, then set according to the following table:
Cleaning cycle
indicator
This determines
the cleaning cycle
time. The RCU
allows you to
choose between
the following
options.
Supreme/Pulit
Residential
cleaners
Commercial
cleaners
Delay Time
indicator
This determines
when the pool
cleaner starts to
work.
A delay allows the
dirt to settle to the
bottom of the pool.
Cleaning action
indicator
Allowing you to
choose from the
following options.
Note:
After 2 minutes, if no button is pressed, the Remote Control Unit will shut-down and the
Pool cleaner will continue to work in the previous settings
When the "Ultra-Clean" and "Walls Only" options finish their cycles, the RCU will return
to default settings.
Fast
1.5 hour cycle
2 hour cycle
4 hour cycle
Immediate start
(Default setting)
Standard
Floor and wall
cleaning.
(Default setting)
Efficient
)
(Default setting
2.5 hour cycle for
everyday use
3 hour cycle for
everyday use
6 hour cycle for
everyday use
One Hour delay
Ultra-clean
Stronger suction and
slower movement
Floor and cove
cleaning only.
3
Extra
3.5 hour cycle
4 hour cycle
8 hour cycle
Two Hours delay
Floor only
Cleans only the
floor and coves.
Walls Only
Cleans walls
and waterline
only.
Publicité
