TaoTronics TT-CL016 SAD Mode D'emploi page 9

Set the Timer
Long press the Power button to set the timer for 30 minutes. The LED
Indicator will blink white when the timer is duly enabled. Long press the
Power button to disable the timer at any time.
Adjust the Light Brightness
EN
Tap and hold the Light Brightness + / - Button to adjust the light brightness.
TROUBLESHOOTING
Problem Possible Cause
No power supply
The lamp
does not
The lamp is not
light up
turned on
Hands are wet
The touch
panel is not
Voltage fluctuation
responsive
causing panel failure
LED failure
LED component failed
06
Solution
Correctly plug in the
power adapter
Refer to the How to
Use section
Touch the panel with
dry hands
Disconnect power to
restart the lamp
Please contact the
TaoTronics Support Team
Power adapter failed
Bad smell
Short circuit
WARRANTY AND SERVICE
In case of any problem, please contact the TaoTronics Customer Care Centre
in your country via the contact information listed in this User Guide.
Please contact the
TaoTronics Support Team
Please contact the
TaoTronics Support Team
EN
07