Sperian Miller Notice D'utilisation page 8

Limit of pendular movement inferior to
30° (Picture 1.8)
Can not stop a sinking (pulverulents or
muddy products) (Picture 1.9)
Precautions of use :
Check that the height of the anchorage
point above the work space is
compatible with the capacity of the fall
arrester and that sufficient clearance
exists, which is compatible with the
characteristics of the device in the case
of a fall.
Check that during use, the cable or the
webbing does not get wound around an
arm or a leg.
Never try to modify or to repair PPE;
Only the manufacturer or a certified
maintenance centre is authorised to
repair it.
Never connect more than one person to
the fall arrester.
Never block the winding out of the
cable, strap.
The cable or the strap must always be
tensed. In case of "slack", the
equipment must be checked by the
manufacturer.
Lateral movements mustn't exceed one
third of the distance ground / working
surface.
Make your movements on a normal
walking speed. Accelerations, climbs
and others engage the clamping
system of the equipment.
This equipment is designed for a vertical
use. If your cable drum has been
designed for a special use (horizontal or
inclined) you must follow the
recommendations of the additional
specific instruction.
AIR CLEARANCE
Before using a cable drum, check for a
minimum space clearance below the
user's feet as necessary, to prevent any
collision with the structure or the
ground.
With a weight of 100 kg in a normal use
(cable drum above the head), the air
clearance D is the stopping distance H +
an additional distance A + 1M. A is
function of the length of cable out L and
the angle formed by the cable (or D,
H, A and L in m and
(Picture 3) (except in special cases - see
specific manual).
8
in °)
ANCHORAGE POINT :
Choose, if possible, an anchorage point
(except in special cases - see specific
manual) that conforms to the standard
EN 795: that is to say elements fixed to
last, to a structure (wall, post...).
Check that the anchorage point :
has a resistance superior to 10 KN
(Picture 1.10)
is situated above the operator (Picture
1.7)
vertical to the work surface : (angle
maxi ±30°).
Suits at best the anchoring system
Does not present sharp edge.
CARABINER
Connector is compliant with standard EN
362
When the carabiner is used for
attachment to an anchorage point,
check for compliance with the
recommendations of the "ANCHORAGE
POINT" paragraph ;
AT THE MOMENT OF CONNECTION TO
THE CARABINER, CHECK THAT THE
LOCKING SYSTEM IS CORRECTLY IN
PLACE
ATTENTION
The carabiner is an essential element for
your safety. We therefore recommend
that you:
attribute the connector to one
person in particular, where
possible;
check the carabiner before each use
in order to safeguard against any
distortion, any sign of use and to
verify the good functioning of the
locking system. (Picture 4)
do not attach and remove it several
times during the same working day,
if it has a manual lock
IN THE SAME WAY, IF THE CARABINER
HAS BEEN USED TO STOP A FALL, IT IS
ESSENTIAL FOR SAFETY REASONS TO
RETURN IT FOR CHECKS.
PERIODIC EXAMINATION
These instructions must be kept with the
product. Fill in the identification sheet and
enter the markings information. This periodic
examination, which verifies the effectiveness
and strength of the equipment is