Thetford SANICON TURBO 97625 Mode D'emploi

Parts: K1 - K3
K1.1
Ref. Description
K1 (1x) Permanent Storage Box
K1.1 Flange on Storage Box
K2 (2x) Angle Brackets
K2.1 (4x) Self Drilling Screws, Washers
K3 (2x) I-Beam Brackets,
K3.1 (2x) Screws, Nuts, (4x) Washers
K3.2 (2x) Self Drilling Screws, Washers
Tools Needed:
■ Drill Bit Size H (17/64), #12/14
■ Hex Head Screw Driver
■ Power Drill
NOTICE AVISO ATTENTION ATENCIÓN DANGER CAUTION AVIS
Thetford Corporation accepts no responsibil-
! ! ! !
ATTENTION ATTENTION ATTENTION
ity or liability for damage to equipment, injury,
or death that may result from the system's
improper installation, service, or operation.
Be sure installation screws are at least 1/4"
from gas line to ensure vibration does not al-
low friction between gas line and screw. Refer
to Fig. B.
Weight placed in box cannot exceed 25
pounds.
P.O. Box 1285
Ann Arbor, MI 48106
www.thetford.com
Permanent Storage
Box Kit
K2
K1
General Guidelines
Questions?
If you have any questions or need assistance, please contact Techni-
cal Support at 1-800-444-7210, available Monday through Friday 8
a.m. to 6 p.m., Eastern Standard Time.
1
Part No.
N° de pièce
Pieza n.°
K3.2
K3.1
K2.1
Do not make any changes to this unit, as this
AVISO AVIS
NOTICE CAUTION
!
could result in property damage or injury.
Plumbing from pump to storage compartment
MUST be plumbed with Schedule 30, 40, 80,
or DWV rated hard pipe fittings or minimum
10 PSI flexible pipe rating for pressure side of
pump.
Plan for sufficient clearance under the RV
once the box mount is installed. Lowest point
of unit MUST be above axles of coach.
Plan the installation so K1 is flush (or re-
cessed) with the side of the RV.
To avoid damage to the hose, it is important to
make sure ALL screws used to secure K1 are
inserted in K1.1, not the box itself!
■ Placement of the hose connection MUST be service-
able by the customer.
■ Ensure the hose is able to reach the box when plan-
ning the installation.
Form/Formulaire n°/Formulario n.° 97628 Rev. A 04.24.17
97625
Made in the U.S.A.
Fabriqué aux É.-U.
Hecho en EE. UU.
K3
Fig. A