Delta ELEKTRA UV EA Serie Instructions De Montage page 25

8
9
Take the (new) lamp by grasping the bulb on the white ceramic prong end, SLOWLY lower
10
the bulb down into the quartz tube and plug it to the 4 pin connector.
11
12
13
Verify that the bulb is lit by viewing the glow of the bulb through the clear plastic union.
V4 Elektra EA Anglais.doc
Marque, Modèles et Brevets déposés - Produits exclusifs
The quartz tube exterior can normally be cleaned
by using acid or spirit vinegar or
pH minus (liquid) with weak concentration (ratio of 4 parts water to
Do not use abrasive cleaners.
Change the quartz tube if necessary.
Note : The quartz tube is attached to the tee fitting,
Seat the quartz tube delicately into the Elektra body up to its receptor.
Screw the 4-pin connector by turning the quartz tube assembly.
Screw the top black plastic housing union.
Put the Elektra unit on the water circulation system by screwing the
Power up the filtration.
one part acid)
it does not unscrew!!
inlet and outlet unions.
Copyright DELTA UV
Page 10