Spector&Co SPECTECH T142 Mode D'emploi page 2

T142 Product Map
Top View
Bottom View (without battery cover)
T142 Operation
** NOTE: Remove battery stopper prior first use (pull on the battery stopper tab)
1. ON: Switch the ON/OFF button to ON (a red LED will flash once to indicate the T142 is powered ON)
2. OFF: Switch the ON/OFF button to OFF
Establishing a wireless connection between the T142 & laptop/desktop computer
** NOTE: System requirements must be met to ensure T142 installation
a) Operating system (supports Windows 7/8/10/XP, Vista/ME/NT, DOS, Macintosh OS)
b) USB port on a laptop or desktop computer
1. Remove battery cover of the T142
2. Detach the USB nano receiver (positioned near AA battery slot) & replace battery cover
3. Insert USB nano receiver to an available USB port on your laptop or desktop computer (NOTE: no
device pairing required)
4. Switch the T142 ON/OFF button to ON (a red LED will flash once to indicate the T142 is powered ON)
Troubleshooting
If a connection is not established between the T142 & USB nano receiver, please follow one of these
Bottom View
No. Description
1 Left button
2 Right button
3 Scroll wheel
4 DPI (Dots Per Inch) button
5 LED light sensor
6 Battery cover
7 ON/OFF switch
8 AA battery slot
9 USB nano receiver