Hannah Montana HM1310ATVD Guide D'utilisation page 14

REMOTE CONTROL
Before using the remote control, batteries must first be installed.
HOW TO INSTALL BATTERIES
1. Loosen the screw to open the battery
compartment cover.
2. Install two (2) "AAA" batteries (not included) into each
remote, paying attention to the polarity diagram in the
battery compartment.
3. Screw the battery compartment cover on the battery
compartment.
CAUTION:
1. Only adults should replace batteries.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries. Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
4. Use only fresh batteries of the required size and recommended type.
5. Dispose of old batteries promptly and properly. Do not burn or bury them.
6. If you do not plan to use your unit for a prolonged period, remove the batteries. Batteries
can leak chemicals than can harm electronic parts.
7. Replace the batteries when the unit stops operating properly.
F
8. To avoid damage caused by leakage of the battery fluid, replace the batteries once every
two years regardless of how much the unit has been used during that time.
9. Old batteries can cause damage to the unit and will void the warranty.
10. Be sure to observe polarity as indicated in the battery compartment. Improper placement
of batteries may damage the unit.
14