IRIS USA IRIS WOOZOO PCF-SDC15T Serie Mode D'emploi page 6

hOW TO USE
Set Combined Delayed Start Time and Timer
To set the product to start at a certain time and then stop at a certain
time:
Using the delayed start button, set the desired delayed start time . After
delayed start time has been set, use the timer button to set the desired
run time .
• The delayed start timer can only be set while the product is off but
plugged in, or after the timer has been set . It cannot be set while
the product is running unless the desired run time has already been
chosen .
• After the delayed start time is set, the delayed start indicator light
will flash . Please set the desired run time while the indicator light
is flashing . The indicator light of the chosen delayed start time will
turn solid after five seconds . Please set the timer before then .
• After the delayed start indicator light turns solid, the product is set
to start after the chosen amount of time . The product will start after
the delayed start time is over and run for the previously chosen run
time .
To set the product to start again at a certain time after it stops running:
Using the timer button, set the desired running time . After running time
has been set, use the delayed start button to set the desired delayed start
time .
• The product will stop running after the set time is over . The indicator
light of the chosen delayed start time will remain solid while the
product is running .
• After the product stops running, the delayed start timer activates
and the product is set to start after the chosen delayed start time .
Stop the Product
Press the power button during operation to turn the product off . The
product will beep before the power turns off .
If product is turned off during oscillation, operation will stop once
product is facing forward . The oscillation indicator lights will blink
until product returns to the forward facing position .
Delayed start time starts Delayed start time ends
Stop Start Run Stop
Timer starts Timer ends
Timer starts Timer ends
Stop Start
Run
Delayed start time starts Delayed start time ends
9
Select Oscillation
The left and right oscillation cannot be done manually . Please use the
oscillation button to change the angle of the product . Forcibly changing the
angle will damage the product .
Horizontal
Press the horizontal oscillation button to start product oscillation left and
right . Pressing the horizontal oscillation button changes the degree of
oscillation as follows:
60° 90° 120°
Oscillation Off
Vertical
Press the vertical oscillation button to start product oscillation up and
down . Press the oscillation button again to stop product oscillation .
Vertical oscillation can also be controlled manually from horizontal to 60
degrees . If vertical oscillation is adjusted manually, the vertical angle will
not reset when the product is turned off .
Run
Adjust the brightness of the Indicator lights
The brightness of all of the indicator lights can be adjusted .
• Strength of the indicator lights can be adjusted by holding the Mode
button for at least 2 seconds while the product is running .
• Hold the Mode button again for at least 2 seconds to return the indicator
lights to the original brightness . T he breeze pattern setting can also be
turned on using the button on the remote .
• The indicator lights will remain at the set brightness even if the product
is turned off and on again . If the product is unplugged, the indicator
lights will reset to the original brightness .
• The brightness of the indicator lights cannot be adjusted by using the
remote control .
Hold for 2 seconds
Hold for 2 seconds
10