Troubleshooting - MoistAir MA0601 Manuel D'utilisation Et D'entretien

Troubleshooting

Trouble
Digital display not
illuminated.
Fan not operating (digital
display is illuminated).
Fan running
continuously.
Poor evaporation of
water.
Bottle empties
completely.
Bottle continues to empty
after complete filling.
Bottle not emptying.
Display blinks or fan
moves slightly when
humidifier is plugged in.
Fan operating slower
than speed registered on
digital display
Humidifier not shutting off
during "DRY OUT MODE"
Alternating "F" and room
humidity displayed.
Alternating "CF" and
room humidity displayed.
Probable Cause
• No Power
Power button has not been
depressed.
• ROOM humidity level is not 3%
more below SET humidity level.
• Reservoir is empty.
• SET humidity level is 65%.
• ROOM humidity level has not
reached 1% or more above SET
humidity level.
• CHECK FILTER message
flashing.
• Mineral buildup on filter.
• This is normal for
initial filling.
• Air is entering water bottle.
• Spring Valve Assembly damaged
or missing post in bottom of base.
• Base full of water.
• Normal
• Humidifier in "DRY OUT MODE".
• Filter not dry.
• Reservoir is empty.
• Filter may be dirty.
• Check 120 volt power source.
• Press power button once to turn
• Raise SET humidity level if
• Increase fan speed.
• Fill humidifier with water.
• A Set humidity percentage of 65%
• Continue to run until desired
• Change to a fresh new filter.
• NOTE: Local water purity varies
• Refill bottle for maximum run time.
• Check for leak in water bottle.
• Check orientation of bottle.
• No action required.
• Humidifier automatically switches
• During "DRY OUT MODE" the
• Fill humidifier with water.
• Replace filter.
• Unplug unit for 30 seconds and
12
Remedy
on.
desired.
operates fan continuously. Adjust
SET level between 25%-60%.
humidity level is achieved. This
may take up to 48 hours initially.
from area to area.
Reposition so that fill valve on
bottom of bottle is depressed by
post in bottom of base.
The base will hold the contents of
water bottle (1.25 gallons).
Continue to run humidifier to
deplete water from base.
fan to (LOW) F1 when "F" and
alternating room humidity is
displayed.
humidifier will continue to run on
"LOW" speed as required for up to
2 hours or until the filter is
completely dry
.
replug in to clear.