Publicité
Les langues disponibles
Les langues disponibles
• The unit weighs approximately 100 lbs. when
installed with the cartridge. Assistance may be
required when installing the eyewash station and/or
the replacement cartridge.
• The area under the unit must be kept clear to allow
the waste water reservoir to drop during use.
• Employees must be instructed in the use of
eyewash stations.
• The eyewash station is intended for the emergency
first aid of victims exposed to fluid, chemical
or particle eye contamination to help flush
contaminating substances from the eyes. In all
cases, the victim must seek medical attention
immediately after flushing.
• An individual or department must inspect this unit
regularly (monthly maintenance is recommended).
Records of these inspections should be kept with
the unit as a log.
CAUTION! Never use an expired cartridge.
Use of an expired cartridge may result in
serious personal injury or serious illness,
including blindness.
• During inspection, follow the proper disarmament
procedure or else fluid flow will begin. Once fluid
flow has started, it cannot be stopped, and a new
Saline cartridge must be installed.
UNIT INSTALLATION
1. On a secure wall, using a tape measure (or the
tape provided), mark a height between 55" and 67",
depending on desired height of unit. (See Figure 1)
Figure 1
55 – 67"
NOTE: Mounting must support 100 lbs. plus the
weight of a person leaning on the unit.
PAGE 2 OF 27
SAFETY CONTINUED
THE ANSI STANDARD Z358.1-2014 REQUIRES THAT:
1. The unit shall be positioned with the fluid nozzle no
less than 33" and no greater than 53" above the
surface on which the user stands, and no less than
6" from the wall or nearest obstruction.
2. Eyewash units shall be in accessible locations that
require no more than 10 seconds to reach. The
eyewash station shall be located on the same level
as the hazard and the path of travel shall be free
of obstructions that may inhibit the immediate
use of the equipment. For a strong acid or a
strong caustic, the eyewash station should be
immediately adjacent to the hazard.
3. Each eyewash station shall be identified with a
highly visible sign provided with the unit, positioned
so the sign shall be visible within the area served by
the eyewash station. The area around the eyewash
station shall be well lit.
INSTALLATION
2. Use a level to
draw a horizontal
line at the mark
made in step 1.
(See Figure 2)
3. Align the top of
the bracket with
the horizontal line
and mount the
bracket. Mount
with appropriate
mounting
hardware (not
included).
(See Figure 3)
CAUTION! Failure to follow and comply with all
cautions and safety instructions may result in
serious personal injury, blindness or death.
NOTE: It is recommended that a consulting
physician or appropriate professional be
contacted for advice on the proper distance
from the hazard to install the eyewash unit.
Figure 2
Figure 3
0621 IH-3838
Publicité
