Samsung SADT-100WM Manuel D'installation page 3

Fix the Back Plate to the Wall Mounted Adaptor using six
4
screws (M3 x L6). (Taking care that the gasket remains in
contact with the Wall Mounted Adaptor.)
Securely fasten the Wall Mounted Adaptor to the wall using
5
the anchor bolts/nuts.
3
Back Plate
Gasket
Wall Mount Adaptor
Separate the dummy plate from
6
the housing top by removing the
two screws and attach the
waterproofing gasket.
(When attaching the gasket, take
care to align the guiding bosses
correctly with the holes in the
housing.)
Align the Wall Mounted Adaptor
7
bosses with the Housing holes
and assemble the Housing to the
Adaptor using four screws
(BH M4 x L22).
Gasket
attachment
after
separating
Dummy Plate
Install the Housing in accordance with the Housing
8
installation manual.
After installing the adaptor, apply silicon sealant around the
9
adaptor and between the adaptor and the wall for water
tightness.
If the wall surface is uneven, pay particular attention that no
gaps are left.
Screw (BH M4 X L22)
Wall Mount
Adaptor
Boss
Gasket
Dummy Plate
4
GB