Pre-Assembly Instructions - m-cro MICRO X10 Notice Originale

Pre-assembly instructions

Your electric scooter is delivered folded up. A er having assambled the handle bar on
it, in a few simple steps, it is unfolded and ready to ride. The following explains how to
unfold the scooter.
1. Press down the rear brake in order to release the front tube hook.
2. Pull up the front tube until it is in vertical position. Close the handle until you hear
the click.
3. Connect the throttle cable with the display cable.
4. Assemble the handlebar with a 4 mm Allen key. Tighten all three screws properly.
WARNING
Image:
Side stand folded in
During each trip, make sure that the side
stand is always folded correctly.
17