Richpower POWER SMITH PWL2042TS Manuel D'utilisation page 4

ASSEMBLY INSTRUCTION
ATTACHING WORK LIGHT
HEADS TO STAND (FIG 2)
1. Place the stand (7) on a flat surface.
2. Rotate the carrying handle (1) straight up. Tighten
the handle locking knob (G3) to secure it in place.
3. Use the locking knobs (G1), flat washers and spring
washers to secure both work light heads to the sides
of the stand as shown in FIG 2.
4. Hang the power cable splitter (H) on the hook (G4).
ADJUSTING THE TRIPOD (FIG 3)
1. Loosen the tripod locking knob (F).
2. Push down the leg connector (A) until the legs (B)
are fully extended and firmly tighten the locking
knob (F).
3. Adjust the height of the tripod by loosening the twist
collars (C1 & C2) and raising the center poles (D1 &
D2) of tripod. Firmly tighten the twist collars when
the tripod reaches desired height.
NOTE
: The maximum height of this tripod is 48".
ATTACHING THE WORK LIGHT
ASSEMBLY TO THE TRIPOD
(FIG 4)
1. Place the work light assembly on top of the tripod.
2. Use the bracket locking system (E1, E2 and E3)
to secure the work light assembly to the tripod as
shown in FIG 4.
NOTE
: Make sure the two locking brackets (E1) are
over the raised metal plate in the middle of the stand.
English
2
G1
FIG 2
FIG 3
E1
E2
FIG 4
4
7
G3
G4
E1
E
E2
E3
D2
C2
D1
C1
A
F
B
E3
1
G1
H
B