Mattel Barbie L3906 Mode D'emploi page 5

Les langues disponibles

1" 1"

A A

B B

C C

Now that the "ENTER", "LEFT" and "RIGHT" Buttons are programmed into the doll, the

necklace's Red LED Light should disappear. Remember, if you made a mistake, you just need

to press the White PROGRAM Button ONCE to turn off the Red LED Light and then press the

White PROGRAM Button AGAIN to turn it back on to start over. In the event that you misplace

your doll, you can also play the game with your DVD remote. Simply press the RIGHT or LEFT

Buttons to choose those directions and use DVD ENTER Button instead of the doll's Blue

ENTER Button.

STEP 1: Program ENTER Button:

(A) Hold the doll in one hand and your DVD remote control in

your other hand. Point the DVD REMOTE IR towards the upper

Clear "Jewel" on the necklace. The distance between your

DVD remote control and the doll's necklace should be 1 inch.

(B) Press the Blue ENTER Button on the back of the doll and

continue pressing it while you keep your DVD remote control facing

the necklace. While pressing the Blue ENTER Button, the Red LED

Light will disappear.

hand to press the DVD ENTER Button once. The Red LED Light will

begin to flash and then it will shine. Release the Blue ENTER Button

and proceed to the next step.

You are finished programming the ENTER Button.

When you program any of the commands, the Red LED Light will

flash 3 times if successful. If not successful, Red LED Light will

flash once.

STEP 2: Program LEFT Button:

REPEAT (A) and (B) FROM "Program ENTER Button"

hand to press the LEFT Button once on your DVD remote control. The

Red LED Light will begin to flash and then it will shine. Release the

Blue ENTER Button, and proceed to next step.

You are finished programming the LEFT Button.

STEP 3: Program RIGHT Button:

REPEAT (A) and (B) FROM "Program ENTER Button"

hand to press the RIGHT Button once on your DVD remote control. The

Red LED Light will begin to flash and then it will disappear.

You are finished programming your doll.