Publicité
Les langues disponibles
Les langues disponibles
HOW TO CHARGE
1. Plug the charger into an AC power outlet.
2. Plug the charging cable into the charging jack of the unit.
NOTE
• Ensure the unit is switched on when charging.
• Unplug the charger after charging is finished.
• The indicator light will illuminate red while charging and turn green when charging has finished.
• Flashing red light will alert you when the unit needs to be charged.
• Flashing green light will turn red when the unit is in use.
MAINTENANCE
• Turn the until off before cleaning it.
• Wash the unit with water or detergent.
• Clean the skid proof pads on the bottom of the unit to make sure the unit stays in place while in use.
• If the unit won't be in use for an extended amount of time, pack it away and place it in a dry place.
TROUBLESHOOTING
PROBLEM
Indicator doesn't
light up when working
Film is too tight
when using
The film's seal is easily
cracked
The unit easily
moves while in use
SPECIFICATIONS
Temperature: ....................................140 ° F
Battery type: ....................................Lithium Battery
Charging time: .................................Approximatively 2 hours
Voltage: ...........................................13,6 V
Power: ..............................................20 W
WARNINGS
European directive 2012/19/UE on Waste Electrical and Electronic Equipment (WEEE), requires that old house hold electrical appliances are not
thrown into the normal flow of municipal waste.
Old appliances must be collected separately to optimize the recovery and recycling of materials they contain and reduce the impact on human health
and the environment.
• To ensure battery safety when charging, please check the AC power supply voltage.
• Don't touch the charger or a live socket.
• Unplug the charger after it's fully charged.
• Unplug the charger immediately and contact our service center if it emits smoke or burns when charging.
• Do not disassemble the unit or change the battery.
• Please dispose of used batteries properly.
• DO NOT put your fingers into the range of the sealing clip when the unit is in use.
• Keep away from children. This unit is not a toy.
• Keep unit away from water.
5 - Instructions for Use
CAUSES
The unit will not turn on
The unit continues to turn on and off
The fil is blocked
after coming off the roll
The film is too tight
There is dust in the seal plates
There is the water on the floor
There is dust on the floor
The skid proof pads aren't dry and clean
SOLUTIONS
Turn on the unit
Turn the unit off for 30 seconds then turn back on
Open the cover
and reinstall the film roll
Install film again
Clean dust off the seal plates
Dry the water on the floor
Clean the floor
Clean the skid proof pads
GB
Publicité
