Chapter 3: Troubleshooting Tips - Neuton CE 5 Mode D'emploi

Chapter 3: Troubleshooting Tips

Most difficulties are easy to fix. Consult the Troubleshooting Table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor adjustments, visit our website at
Neuton Inc. Toll Free at: 1-866-NEUTON1 (638-8661) for assistance.
Always remove the Safety Key and Battery before performing any adjustments, maintenance, or repairs to your Mower.
Troubleshooting Table
P C
ROBLEM
⇒ Check to make sure you have inserted the Trimmer/Edger all the way into the port(s).
The Trimmer Motor
fails to start with the
⇒ Check to make sure that you properly inserted the Safety Key and the green Status Indicator
Safety Key inserted,
and the Control Bar
⇒ Check to see if the white Button on the Safety Key has popped up; if it has, then depress the
depressed.
⇒ Check that you installed the Battery correctly and that the Battery is fully charged. The green
⇒ Check to make sure the Mower/Auxiliary Switch is in the correct position.
⇒ Make sure you follow the correct starting sequence of sliding the orange Start Knob to the left
⇒ The Battery has completely depleted its charge. Recharge the Battery fully or replace it with a
The Trimmer stops
while trimming (for
reasons other than
⇒ The Trimmer was probably overloaded. If the Status Indicator Light is out, the Circuit Breaker
releasing the
Control Bar).
⇒ The white Circuit Breaker Button in the Safety Key may not be pushed in fully. Reset it and try
⇒ The Battery was probably not at full charge prior to Mowing. Charge the Battery, if necessary.
The Trimmer runs,
but the cutting
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting height or
performance is
unsatisfactory, or
there is a loss of
power.
⇒ The Battery was probably not at full charge prior to Trimming. Charge the Battery, if
The Battery loses its
charge quickly.
NOTE: You will need to charge a new Battery at least five (5) times to achieve maximum cutting time.
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting height or
⇒ The Battery may be getting old. After some time, usually about five (5) years, you will need to
Safety & Operating Instructions
NEUTON Trimmer -
A
ORRECTIVE CTION
Light is ON.
Button to reset it.
Status Indicator Light should be ON. If not, replace with a fully charged Battery or recharge
the Battery.
and squeezing the orange Control Bar.
fully charged Battery.
inside the Safety Key has tripped to protect the Motor. Reset Breaker by pushing in the white
Button in the Safety Key and restart the Trimmer.
again.
narrow your cutting swath and try again.
necessary.
narrow your cutting swath and try again.
replace the Battery.
www.neutonpower.com or call
7