Publicité
Les langues disponibles
Les langues disponibles
3-IN-1 MULTIFUNCTIONAL FLOOR CLEANER
One charging time
Continuos working time after one
recharge
Size
Net weight
Autonomy
Our company reserves the right to any technology and design changes of the product due to conti-
nuous product improvement. We reserve the right of final explanation.
INSTRUCTIONS
PRODUCT USE
PREPARATIONS
•
Check the electricity quantity of the appliance before use, if no electricity, charge it promptly
(refer to "charge the product") use it after fully charged
•
Choose the mode according to the request. If only water sucking, use it directly, if clean the
floor, mix the cleaning agents according to the machine rule.
START TO WORK
•
The on/off switch of the appliance is at the top of the handle as pic1, press the button to start.
The mode is low level at the beginning, then press again the button, the appliance stops. When
the appliance is working, press the low/high button to switch the mode.
•
Trigger of releasing buttons a pic2, the brush starts to spray water when pressing the trigger,
the spray stops when stop pressing. (in high level mode, water sucking and spraying speeds
up than low level).
•
After use, put the appliance on the tray provided vertically (pic3).
Reminder
Do not pick up foam liquid.
ADD WATER TO CLEAN WATER TANK
•
Press the release button to take out the clean water tank (pic1)
•
Open the cover, add the clean water (under 60) until the water line (pic2).
•
Tighten the cover, cover make sure no loosening (pic3)
•
Install the clean water tank, installation completed.
3 ~ 4
25±3
1110*270*250
≈3.3
Up to 30 minutes at minimum speed using the standard accessory
(the battery performance could range if you change the
settings)
25
Publicité
