Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - stayer TM800A Instructions D'emploi

Tip:
Benefits:
6.3 Preselecting the speed (Fig. 7/Item 6)
6.4 Clockwise/Counter-clockwise switch
(Fig. 7/Item 6)
Change switch position only when the drill is
at a standstill!
→
Direction
6.5 Drill / hammer drill selector switch
(Fig. 8/Item 3)
Change switch position only when the drill is at a
standstill!
Drill
Hammer drill
6.6 Gear Selection, Mechanical
- Actuate the gear selector 9 only when the
machine is at a standstill.
Two speed ranges can be preselected with the gear
selector 9.
1st gear:
Low speed range; for working with large
drilling diameter or for driving screws.
2nd gear:
High speed range; for working with small
I 2
drilling diameter.
ENGLISH
Switch position
→
→
(TM900A-TM900)
6.7 Tips for working with your hammer drill
6.7.1 Drilling concrete and masonry
6.7.2 Drilling steel
6.7.3 Inserting/Removing screws
6.7.4 Starting holes
6.7.5 Drilling tiles

7. Replacing the power cable

8. Cleaning, maintenance and
ordering of spare parts
8.1 Cleaning
20