Télécharger Imprimer la page

BatteryLabs MegaCharge Serie Mode D'emploi page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
Manual
BatteryLabs MegaCharge
1: Product specifica�ons
AC input: 220-240 VAC 50-60 Hz
DC output: indicated by the label on the product
Efficiency: >85%
Cer�ficates: CE, RoHS
Charge characteris�c: CC/CV , IC controlled
2: Versions
Suited ba�eries: Lead/acid, SLA, Silicone, Gel, Lead/crystal, Li-ion, LiPo, LiFePO4
Power: 120W, 180W, 240W, 360W,600W, 1000W
Connector: C13(V), XLR-M 3P, GX-F 3P, SB50, Et Al
3: Security
The charger is protected in case of the following events: Short circuit, reverse polarity, excessive input
voltage, overhea�ng.
4: Usage
- Connect the charger to 220-240 VAC power source. Then connect it to your rechargable ba�ery/product.
When the charger is fi�ed with a powerswitch, switch it to on posi�on.
- When LED 1 is red, charger has power.
- When LED 2 is red, charger is charging.
- When LED 2 is green, charger is finished.
- Charge only the type of ba�ery for which the charger is intended. This is indicated on the label of the
charger.
- Do not charge any ba�eries that are broken. It is not possible for the charger to ascertain whether ba�eries
are broken so that in this case the risk of overcharging exists.
- Charge ba�eries no longer than specified by the ba�ery manufacturer. If LED 2 does not turn green within
the prescribed �me, please contact the specialists of Ba�eryLabs.
- Violent shaking may damage the charger, so we advise not to put the charger in the storage compartment
of an electric scooter.
- Make sure the vents of the charger are not blocked during use.
- Do not use the charger in wet or damp condi�ons. Unless the charger is a cer�fied waterproof charger.
- When the charger is damaged, it should no longer be used.
- In case of problems, you should contact your dealer or the Ba�eryLabs specialists.
5: Warranty
The warranty on the product is 2 years. In addi�on, the following condi�ons must be observed:
- Warranty is given based on the serial number (Serial No.) on the product.
- Warranty will void by opening and/or modifying the charger. This includes changing or removing the output
connector.
- Warranty does not cover damage from falling / vibra�on / impacts, water damage, improper act or not
following the instruc�ons correctly.
There are terms and condi�ons applied on this product, available at www.ba�erylabs.nl.
Series Charger

Publicité

loading