Connecting To Your Computer - Targus WIRELESS Numeric Keypad Manuel De L'utilisateur

Targus Wireless Numeric Keypad

Connecting to Your Computer

1. Remove the USB receiver from the back of the keypad.
2. Plug the USB receiver into an available USB port on your computer.
3. Power on the keypad by using the On/Off switch located on the back of
the keypad.
This keypad is a plug and play device. It should automatically operate
when the USB receiver is connected to the computer.
NOTE: WHEN THERE IS COMMUNICATION BETWEEN THE KEYPAD AND THE RECEIVER, THE
LED ON THE RECEIVER WILL FLASH.
4