Using The Ar Psa; Find The Correct Tube For Your Ear - Audiovox Acoustic Research Guide De L'utilisateur

Using the AR PSA

The first time you use the AR PSA, you'll need to
find the most comfortable fit for your ear and for the
environments where you plan to use the earpiece.
First of all, you should make sure the correct tube is in
for the ear you want to wear the earpiece on.

Find the correct tube for your ear

The Acoustic Research earpiece comes with three tubes:
• a thin tube for the right ear (pre-installed on the
earpiece)
• a thin tube for the left ear
• a wide tube and dome that works on both ears
If you plan to use the earpiece on your right ear,
great...the earpiece is ready for you to try out.
If you plan to use the earpiece on your left ear, or
if you want to use the earpiece with the wide tube,
you'll need to take the tube for the right ear off the
earpiece and replace it with the other tube.
What is the wide tube for?
The wide tube provides more volume than the thin tubes. Before
installing the wide tube, we recommend that you try a thin tube at all
four volume levels (see page 9 for information on adjusting the volume).
If you want still more volume than the third level, follow the instructions
below to install the wide tube.
To change the tube:
1.
Find the part of the tube
that attaches to the
earpiece. Gently rotate this
section of the tube so that
the sound inlet is exposed
(as shown here).
2.
Pull the tube straight off the
earpiece.
Note: If you're installing the wide
tube, you can skip steps 3 and 4.
IMPORTANT: DO NOT pull the tube off at an angle. Doing so could harm the
tube connector or the components in your earpiece and void your warranty.
6
All manuals and user guides at all-guides.com
Sound inlet
3.
Once you've removed the tube
completely, use your thumb to
gently pry the dome from the end of
the tube.
4.
Find the other thin tube that came in the package.
Attach the dome to the end of this tube by pushing
the opening on the back of the dome gently onto
the end of the tube. Push the dome onto the end
of the tube as far as it will go. Make sure it is
securely fastened.
5.
Before you attach the tube to
the earpiece, make sure the
exposed part of the earpiece
is clean of dust or other
particles. Use the cleaning
brush that came with your
charger.
6.
Find the part of the tube that
connects to the earpiece
(shown here).
Note: A thin tube is shown here for
illustration. Step 6 applies for the wide
tube as well.
7.
Place the hole on the bottom
of tube connector over
the post on the top of the
earpiece (shown here). Turn
the tube sideways on the
top of the earpiece and push
straight down to attach the
tube to the earpiece.
8.
Rotate the tube into the
correct position for use with
the earpiece.
Note: A thin tube is shown here for
illustration. Step 8 applies for the wide
tube as well.
Dome
Tube connector
Post
7