Speaker Connection - Paradigm Cinema 100 3.0 Mode D'emploi

WALL MOUNTING
Align keyhole slots (see inset) on rear of speaker with protruding screw heads on the bracket, then using
an "in and down" motion mount speaker on bracket.

SPEAKER CONNECTION

3.258
Turn your amplifier OFF before connecting speakers.This will avoid damage
which could result from accidental shorting of speaker cables.
The following chart identifies the minimum gauge requirements for various cable lengths:
MINIMUM GAUGE REQUIREMENTS
LENGTH
Under 4.5 m (15 ft)
Under 9 m (30 ft)
Over 9 m (30 ft)
Your speakers are equipped with binding posts that can be used with pin connectors, as well as with
bare wire. Refer to the diagram below and using high-quality speaker cable (see your dealer), connect
one speaker at a time to your receiver/amplifier. Connect the red (+) amplifier terminal to the red (+)
speaker terminal and the black (–) to the black (–) (see next page). Push binding posts to secure.
Turn your amplifier on and listen to your speakers. If you notice a complete lack of mid-bass and a
dislocated image, one or more of your speakers may be connected out-of-phase (their polarity is
reversed). Re-check to ensure that each speaker's cable is connected with correct polarity: red (+) to
red (+) and black (–) to black (–). Make sure wires are firmly fastened. Push binding posts to secure.
13
(CONTINUED)
CINEMA ™ 200, 400
DIAMETER
1.3 mm (0.05 in)
1.6 mm (0.06 in)
2.0 mm (0.08 in)
TRIO
GAUGE
16 awg
14 awg
12 awg