Bissell BigGreen Commercial BG1000 Mode D'emploi page 5

A
ssembly
1.
Unpack the enclosed packet. Enclosed
packet contains one handle bolt and one
carry handle.
2. Take handle and align to back of vacuum
— make sure metal guide is aligned in
handle receptacle.
3. Push handle bolt through carry handle.
4. Plug short machine cord into vacuum base.
5. Align with hole in center of vacuum
handle (push through into vacuum bag
housing). Tighten bolt with screwdriver
until it is completely secured.
6. Attach plastic wand to hose by pushing
wand into open hose cuff. Push until hose
cuff and raised ring on wand meet.
7. Facing back of vacuum, attach hose to
vacuum by screwing plastic machine end
counter clockwise into bag housing.
8. Slide wand into the hole by the On/Off
switch.
9. Place crevice tool on knob next to the
hose. Slide brush over crevice tool.
10. Attach cord holder to short machine cord
and 50-foot cord.
11. Wind cord. Use two lower cord and one
upper cord holders.
w w w . b i s s e l l c o m m e r c i a l . c o m
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum or
deep cleaner may aggravate this
condition.
2.
4.
1 - 8 5 5 - 5 4 4 - 7 3 3 6
5