Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4 ELECTRICAL CONNECTION
4.1
WARNING / Fire hazard.
Do not use an extension cord. If not, you can cause electrical shock, fire, death. If the power cord is too short,
have a qualified electrician or service technician install an outlet near the freezer.
4.2
WARNING / Electrical shock hazard.
Plug into a grounded wall outlet. Do not remove ground. If not, you can cause electrical shock, fire, death.
4.3
If the power cord is damaged, have it replaced by an authorized electrician.
5 TEMPERATURE CONTROL
5.1
The first time you turn on the appliance, let it run for a few time before putting the products inside. This will
ensure the cabinet is thoroughly chilled before products is put in. During some time the compressor will run
constantly. This is normal.
5.2
The thermostat is located behind the engine compartment grill. The thermostat position No is pre-setted by
the manufacturer and normally can cover your needs. If you want to the pre-setted position No, you have to
turn the thermostat knob clockwise, from position 1 warmest temperatures to position 7 coldest
temperatures. We advise you to set it between 3 -4 position. For models with electronic thermostat conduct
with the supplier.
5.3
To turn the appliance off, turn the thermostat knob to 0.
5.4
WARNING / Setting the thermostat knob to 0 , you stop the cooling cycle but does not shut off the power
to the appliance.
6 CLEANING YOUR APPLIANCE
6.1
WARNING / Unplug the appliance, before cleaning.
6.2
Use a soft sponge or cloth to clean the gasket and the interior.
7 DEFROSTING YOUR FRREZER
7.1
WARNING / Unplug the freezer, before defrosting.
7.2
WARNING / Do not places electrical devices such as fans air hair dryers in freezer for faster defrosting. You
can cause electrical shock or death.
7.3
Remove all frozen products for cleaning the frost. Leave the frozen products in another freezer or in a cool
area.
7.4
Leave door open.
7.5
Open the defrost water drain tap ( located on the inner bottom ) and use a large sponge to remove water
faster.
7.6
Use a plastic scraper to remove frost.
7.7
DANGER / Do not use a knife or other sharp tools for defrosting. You can cause damage.
7.8
When the interior of the freezer is dry, replace the drain tap.
7.9
Close the door.
7.10
Plug in and turn on the freezer at least 1 hour before replacing the frozen products.
8 MAINTENANCE
8.1
If your appliance does not work or if it does not work properly, before calling for service, see troubleshooting
guide on 11.
8.2
If the condenser has aluminum sheets dirty or dusty:
WARNING, unplug the freezer from the power and clean them with a vacuum cleaner or soft paint brush.
Clean also the blades of the ventilator by using piece of cloth.
8.3
WARNING / Other maintenance jobs can proceed only from authorized technicians.
9 TIPS ON SAVING ENERGY
9.1
Install it well
Far from heat sources, from direct sunlight, in a well aired place and
keeping free the space around from engine compartment openings.
9.2
Close the door (-rs)
Make sure that the door (-rs) is properly closed.
9.3
Keep the condenser clean if it has aluminum sheets.
5
Publicité
Table des Matières
