XciteRC Rocket 400 Mode D'emploi page 2

# 15001119 Rocket 400 GPS HD camera
›
The camera angle is controlled by the AUX-1
control dial.
›
If no microSD card inserted, the red and green
LED flashes alternately.
›
Is a microSD memory card inserted, the LEDs
light up red.
Features:
›
5 Megapixel HD camera
›
Camera angle is controlled via Rocket 400 transmitter
›
Camera resolution: 2592 x 1499 Pixel
›
Video resolution: 1280 x 720 Pixel, 60 FPS
›
Built-in microphone
›
microSD memory cards max. 32 GB
Insert the microSD memory card before powering up the Rocket 400.
If no microSD card inserted, the red and green LED flashes alternately. Is a microSD memory card
inserted, the LEDs light up red.
The camera angle is controlled by the AUX-1 control dial.
Recording a video:
1. Press camera button for about 2-3 seconds. The red LEDs starts flashing, video recording is started.
2. To stop recording press the camera button, the red LED flashes 2 – 3 times, the video is saved
on the memory card.
Taking a photo:
1. To take a photo, press the camera button once. The green LED light up shortly.
2. Now the camera is ready for the next photo.
Insert the memory card in the deliverd USB Card Reader to read the files. There are two folders on the
memory card: PHOTO and VIDEO where the images or videos are stored chronologically.
XciteRC Modellbau GmbH & Co. KG - Autenbachstrasse 12 - D-73035 Göppingen - E-Mail: info@xciterc.de - Web: www.XciteRC.com
Installation Guide
1. Attach the camera to the Rocket 400 bottom with the provided screws.
Servo
Camera
2. Connect the servo and camera to the 5 V outlet of the Rocket 400. Servo (3-pole) to S1,
camera (2-pole) to S2
WARNING: Never connect servo or camera to the 12 V outlet, this will cause
servo or camera damage!
Using the camera:
Servo from left to right:
brown, red, orange
Camera from left to right:
black, red
WARNING: check the
polarity, otherwise the
camera could be
destroyed!