ensto BETA-BT Serie Instructions D'installation Et De Fonctionnement page 13

When the application has found your heater, you can see the default name "New heater" on your
»
mobile display.
» Press the "New heater" button within 45 seconds.
The blue LED indicator (B) turns off, when the pairing is completed or 45 seconds is exceeded.
»
» Put the adjustment knob (D) in place.
Now you can find your heater in "Devices / My devices".
•
7.2. Temperature Change with Calendar, Boost and Vacation
• With this application you can change the setting temperature adjusted with the adjustment knob (D) on
the heater.
• The change may be either a rise or a drop in temperature.
• The blue LED indicator (B) is on when the temperature change is in use.
• Press the button on home display to enter the editing mode.
"Calendar" is intended for weekly reoccuring events. For example, on weekdays you can drop the tempera-
•
ture overnight, as well as when you are away from the building. Note! When making settings for overnight,
the night must be in two sections.
"Boost" is intended for a temporary temperature change. For example, after a shower you can raise the
•
temperature in the bathroom, so that the floor will dry faster.
"Vacation" is intended for long-term changes in temperature, e.g for a weekend break or an annual holi-
•
day.
The "Calendar", "Boost" and "Vacation" buttons are on / off buttons. When the temperature change is acti-
•
vated, the "Calendar" and "Vacation" buttons are green, the "Boost" button is orange.
When the function "Adaptive temperature change" is active, the thermostat will advance the heating, so
•
that the desired temperature has been reached at the scheduled time. By default, the function is on.
7.3. External Temperature Control
You can use external temperature control, if external voltage has been connected to the heater.
•
• Disable / Enable the function from "Settings / External control".
• From "Temperature" you can set desired absolute temperature value. The default temperature setting for
external control is 10 °C.
• "Temperature change" can be either a rise or a drop in the set point temperature.
The blue LED indicator (B) is on when the external control is in use.
•
When the the external temperature control is enabled you cannot use the adjustment knob (D) for setting
•
temperature.
7.4. Home Screen, figure 6.3
F
Active device
G
Set point temperature
H Actual temperature
On / Off button
K
L Enter editing mode
7.5. Wireless connection between Master and Slave heaters
• You can select any Beta Bluetooth® heater as a Master heater.
Establish a wireless connection, figure 6.4.
•
» Go to "Devices".
Select a heater as Master. Tap the three dots on the right to open the dialog box.
»
» Select one or more heaters as Slave.
• The Master heater can wirelessly control up to 10 Ensto Bluetooth® heaters.
• The Slave heaters operate in accordance with the Master heater. You cannot adjust the temperature with
the adjustment knob on the Slave heater.
• All heaters must be connected to power supply. Wiring between the heaters is not needed.
RAK124 / 6.5.2021
13 / 72