Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRCUTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
14
13
13
5
M12x40
M12x1,25x40
This towbar is designed to assembly in following cars:
KIA RIO II, 4 doors, produced since 08.2005 till 2009, catalogue no. T48
and is prepared to tow trailers max total weight 1100 kg and max
vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
M12x1,25x40
1
15
M12x70
2
M8x30
3
From manufacturer
The instruction of the assembly
1.
For the purpose of installing of
the towbar it is not necessary to
disassemble
However one ought to unscrew
all bolts holding the bumper
from the bottom and make in
the bumper small cut outs (as
shown on the fig. 2).
2.
By the internal side of the
chassis members are factory-
4
made
holes
M12x1,25mm. One ought to
fix to them side brackets of the
towbar (pos. 4 and 5) using
bolts M12x1,25x40mm (pos. 7)
– loosely.
3.
Slip the main bar of the towbar
(pos. 1) between side brackets (pos. 4 and 5) and fix using bolts
M12x40mm (pos. 8).
4.
Fix tow-ball (pos. 2) using bolts M12x70mm (pos. 6) from accessories.
5.
Fix the socket plate (pos. 3) as shown on the fig. 1.
6.
Tighten all bolts according to the torque shown in the table.Connect
Fig. 1
electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station).
7.
Complete paint layer damaged during installation.
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
the
bumper.
with
thread
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
Fig. 2
M10 - 50 Nm
M16 - 210 Nm
Publicité
