Turn On Your Headset; Pair It With Your Phone; Turning On/Off Call Alert Vibrate; Wear It How You Like It - Jabra BT 500V Mode D'emploi

2

Turn on your headset

• Press the answer/end button to turn on your headset.
• Press and hold the answer/end button to turn off your headset.
3

Pair it with your phone

Before you use your Jabra BT500v, you need to pair it with your mobile phone.
1. Put the headset in pairing mode
• Make sure the headset is on.
• Press the pairing button marked
2. Set your Bluetooth phone to 'discover' the Jabra BT500v
Follow your phone's instruction guide. This usually involves going to a 'setup, '
'connect' or 'Bluetooth' menu on your phone and selecting the option to 'discover' or
'add' a Bluetooth device.* (See example from a typical mobile phone in fig 5. )
3. Your phone will find the Jabra BT500v
Your phone then asks if you want to pair with it. Accept by pressing 'Yes'
or 'OK' on the phone and confirm with the passkey or PIN = 0000 (4 zeros).
Your phone will confirm when pairing is complete. In case of unsuccessful pairing,
repeat steps 1 to 3.
4

Turning on/off call alert vibrate

The Jabra BT500v has a unique call alert feature that vibrates to inform you that are
receiving a call. The vibrate function is enabled when you first turn on Jabra BT500v.
If you turn on the device in the usual way without touching the volume button, the
vibrate function will remain enabled.
1. To turn off the vibrate, hold the volume down button while you turn the headset on.
2. If you wish to re-activate the vibrate, hold the volume up button while you turn the
headset on.
5

Wear it how you like it

The Jabra BT500v is ready to wear on your right ear. If you prefer the left, gently rotate
the MiniGel™ ear piece 180°. See fig. 1.
For optimal performance, wear the Jabra BT500v and your mobile phone on the same
side of your body or within line of sight. In general, you will get better performance
when there are no obstructions between your headset and your mobile phone.
4
.
6

How to...

Answer a call
• Tap the answer/end button on your headset to answer a call.
End a call
• Tap the answer/end button to end an active call.
Reject a call (dependent on your phone supporting this feature)
• Press the answer/end button when the phone rings to reject an incoming call.
Depending on your phone settings, the person who called you will either be
forwarded to your voice mail or hear a busy signal.
Make a call
• When you make a call from your mobile phone, the call will (subject to phone
settings) automatically transfer to your headset.
Activate voice dialing (dependent on your phone supporting this feature)
• Tap the answer/end button. For best results, record the voice-dialing tag through
your headset. Please consult your phone's user manual for more information about
using this feature.
Redial last number (dependent on your phone supporting this feature)
• Press the answer/end button.
Adjust sound and volume (dependent on your phone supporting this feature)
• Press the volume up or down (+ or -) to adjust the volume.
• To mute, press both volume up and down at the same time. A low beep alert plays
during a muted call.
• To un-mute, tap either of the volume buttons.
7

What the lights mean

What is the mean about your headset
What you see
Flashing every second: active on a call
Flashing blue light
Flashing every three seconds: in standby mode
Flashing blue light
Running low on battery
Flashing red light
Charging
Solid red light
Fully charged
Solid green light
In pairing mode – see section 3
Solid blue light
5