AUTO-HAK F10 Instructions De Montage page 4

FITTING INSTRUCTION
6
5
6
12
8
A
B
3
2
This towbar is designed to assembly in following cars:
PEUGEOT 605 produced since 1990 till 2000, catalogue number F10 and
is prepared to tow trailers max total weight 1500 kg and max vertical mass
75 kg.
Thank you for buying our product. Their reliability has been
confirmed in many tests. Reliability of towbar depends also on correct
assembly and right operation. For this reasons we kindly ask to read
carefully this instruction and apply to hints.
The towbar should be install in points described by a car producer.
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
C
9
4
1 A
C
7
B
From manufacturer
1. Take out a spare wheel.
2. Disassemble a rear bumper and take out muffler from rubber handles.
3. Through existing holes in left and right chassis members put bolts on
the jibs M10x35mm (pos. 4).
NOTE !!! Bolts on the jib put through elliptic holes.
4. On protruding bolts put side brackets (pos. 4 and 5) and fix loosely.
NOTE !!! Between frame and side brackets (pos. 4 and 5) on holes
(pos. A) put big washers ø42x ø13x3mm (pos. 12).
5. Put main bar of the towbar (pos. 1) and fix with side brackets using
bolts M12x35mm (pos. 8) by holes pos. B and using bolts M10x30mm
6
(pos. 9) by holes pos. C.
6. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x75mm
(pos. 7) from accessories.
7. Fix tight all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station)
9. Complete paint layer damaged during installation.
10. Reassemble a bumper and a muffler
6
12
8
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km of exploitation check all bolts. The ball of towbar must be always
kept clear and conserve with a grease.
The instruction of the assembly
.
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE