AUTO-HAK LN01A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
M10x35
A
B
M12x1,25x70
This towbar is designed to assembly in following car:
LAND ROVER FREELANDER, (LN), produced since 03.1998 till
09.2006, catalogue no. LN01A and is prepared to tow trailers max total
weight 2000 kg and max vertical load 140 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
M10x35
B
1
M12x1,25x70
3
From manufacturer
1. From the right side of the frame unscrew original tow handle (not
A
used any more).
2. Put the main bar of the towbar (pos. 1) to the frame that way, so
holes (pos. A) agree to threaded holes and fix using bolts
M10x35mm (pos. 5), and next through holes (pos. B) fix using
bolts M12x1,25x70mm (pos. 4).
3. Fix body of the automat and the socket plate (pos. 3) using bolts
M12x25mm from accessories. Place tow-ball according to
supplied instruction.
4. Tighten all bolts according to the torque shown in the table.
5. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized service
station).
6. Complete the paint coating damaged during instalment.
M6 - 11 Nm
M12 - 87 Nm
2
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm