AUTO-HAK Z01 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
4
7
7
5
This towing hitch is designed to assembly in following cars:
MITSUBISHI L200, Pick-up (K60T), produced since
, catalogue number Z01 and is prepared to tow trailers
since 2033 till 04.2006
max total weight up to 2700 kg and max vertical mass 100 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be installed in points described by a car producer.
4
7
1
14
6
2
3
10.1996 till 2002 and
From manufacturer
1. Disassemble original bumper-pipe from frame of the car
chassis.
7
2. To place after original bumper-pipe put main bar of the
towbar (pos. 1) and fix it through holes in side brackets using
5
bolts M12x35mm (pos. 7) from equipment. From inside of
the frame put fish-plates (pos. 4) as shown in the drawing.
3. On ends of pipe put in supplied plugs (pos. 5).
4. Fix tow-ball (pos. 2) with socket plate (pos. 3) using bolts
M16x50mm (pos. 6) as shown in the drawing.
5. Tighten all bolts according to the torque shown in the table.
6. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
7. Complete paint layer damaged during installation.
After installation of the towing hitch you should get adequate note in
registration book (at authorised service station).The car should be equipped
with:
Indicators
Tow mirrors
Check all bolts and nuts after 1000 km of exploitation. The ball of the
towing hitch must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M6 - 11 Nm M8 - 25 Nm
M12 - 87 Nm M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm