AUTO-HAK B10A Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
4
Fig. 1
This towing hitch is designed to assembly in following cars:
BMW X5, produced since 08.1992 till 2002, catalogue no. B10A and is
prepared to tow trailers max total weight 3500 kg and max vertical mass
150 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
1
4
6
5
3
From manufacturer
A
1. For the purpose of the installings of the towing hitch one ought to
disassemble the bumper with the metal fulfilment (metal fulfilment of the
4
bumper will not be assembled again).
2. Apply the main bar of the towing hitch (pos. 1) on the rear panel of the
vehicle (on protruding original bolts) and fix loosely through holes A. Use
distance sleeves (pos. 4) from the towing hitch accessories (see fig. 1).
3. Fix body of the automat (pos. 5) and the socket plate (pos. 3) using bolts
M12x25mm (pos. 6) from accessories. Place tow-ball (pos. 2) according to
supplied instruction.
4. Install the bumper after cut out the fragment in its axis (width 80mm and
depths 90mm). For the purpose of installings of the bumper use rivets (pos.
11) and washers (pos. 12) from the towing hitch accessories (see fig. 2).
5. Tighten all bolts according to the torque shown in the table.
6. Connect electric wires of 7-poles socket according to the instruction of the
2
car. (Recommend to make at authorized service station).
7. Complete paint layer damaged during installation.
After install the towing hitch you should get adequate note in registration
book (at authorised service station). The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be
always kept clear and conserve with a grease.
The instruction of the assembly
12
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
11
Fig. 2