Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
A
4
7
9
8
8
6
This towbar is designed to assembly in following cars:
KIA CARNIVAL produced since 01.2000 till 07.2001 and since 08.2001
till 12.2005, catalogue no. T16 and is prepared to tow trailers max total
weight 2000 kg and max vertical load 80 kg.
Thank you for buying our product. Their reliability has been
confirmed in many tests. Reliability of towbar depends also on correct
assembly and right operation. For this reasons we kindly ask to read
carefully this instruction and apply to hints.
The towbar should be install in points described by a car producer.
A
9
B
6
4
7
3
From manufacturer
1. Disassemble the rear bumper.
2. Disassemble brackets from the bumper (not used any more).
3. Put main bar of the towbar (pos. 1) to chassis members and fix by bolts
M12x40mm (pos. 6) in points pos. A.
4. Through holes pos. B drill holes in rear panel using bit ø10,5mm.
5. Disassemble main bar. Fix main bar and the bumper together. NOTE!
Cut out fragments of the bumper before join - see figure 2.
6. In this way prepared unit put again to chassis members and fix in points
8
pos. A and B as shown on the drawing.
7. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x75mm (pos.
4) from accessories.
8
1
8. Tighten all bolts according to the torque shown in the table.
9. Connect electric wires of 7-poles socket according to the instruction of
5
the car. (Recommend to make at authorized service station)
Complete paint layer damaged during installation
10.
18
2
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
The instruction of the assembly
200
200
55
Plastic „gutter"
Rys 2.
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
.
Plastic
65
M10 - 50 Nm
M16 - 210 Nm
Publicité
