Publicité
Les langues disponibles
Les langues disponibles
How to Section:
Water cooling
Arc Mini is made with water cooling in mind. The top of the Arc supports radiators, up
to 2x120mm in size. To mount a radiator, first remove the top panel by using the two
rear thumb screws securing it in place. Secure the radiator using the correct mounting
screws supplied with the radiator. When you are sure the radiator is secured correctly,
put back and secure the top panel.
A convenient place for the pump and water tank is in the bottom where the additional
fan can be placed.
Installing Graphic cards longer than 260mm
To be future proof, Arc Mini supports graphic cards longer than 260mm by removing
the upper HDD-Cage. To remove this, first remove the two thumbscrews securing it,
remove (or rotate) and reinsert and secure the thumbscrews. When the HDD-Cage is
removed the chassis supports graphic cards with lengths up to 400mm!
Rotatable HDD-Cage
There are two HDD-Cages in Arc Mini, where the top one is removable and rotatable.
When removed, the chassis supports longer graphic cards, or provides better airflow.
By rotating it the HDD-Cage can work as an air guide for the front fan, directing air to
the graphic card or by placing it in the original position, it's optimized for a clean build
with excellent HDD cooling and cable management.
Bottom optional fan position
This bottom fan hole, protected by a filter underneath the chassis, is excellent for pro-
viding cool air, straight into the chassis, cooling both the GPU but also the CPU. When
using water cooling, this is a convenient place for the pump and reservoir, securing
them in place using the fan grill holes.
Cleaning the filters
The filters are placed at the usual air intakes to prevent dust from the system. When
they get dirty they also obstruct the airflow and they need to be cleaned with a regular
interval for optimal cooling.
•
To clean the PSU/Bottom fan filter, just remove it from the chassis by pulling it
backwards and remove all dust gathered on it.
•
To clean the front filters, the front fans needs to be disconnected from the power
source. When they are disconnected, remove the front panel using the handle
in the bottom, pull outwards and the front should come off. Clean the filters, then
snap it back on. Don't forget to connect the fans afterwards.
•
To clean the top filter, remove the two thumbscrews in the back, securing the top in
place. Pull the top backwards and upwards gently and it should come off. Clean it
and put it back by aligning the sliders over the slide holes, and pushing it forward.
Secure it using the thumbscrews.
GB
5
Publicité
