AUTO-HAK H15 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
13
8
5
8
5
Fig. 1
This towbar is designed
SKODA OCTAVIA I, ESTATE, (1U), 4WD, produced since 11.1999 till
12.2010 and VOLKSWAGEN GOLF IV, 3/5 doors, only 4 Motion, produced
since 08.1997 till 10.2003, catalogue no. H15 and is prepared to tow trailers max
total weight 1650 kg and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
exploit. For this reasons we kindly ask to read carefully this instruction and apply
to hints.
The towbar should be install in points described by a car producer.
8
1
9
14
9
6
3
to assembly in following
From manufacturer
1. Remove the rear bumper and a metal support of bumper (this metal part will
not be used any more).
5
2. Find two holes at the bottom of the car next to a chassis under the conservation
layer.
3. Slide the main bar (pos. 1) into the chassis and then fix with M10x40mm bolts
(pos. 5) and big washers ø30xø10,5x2,5mm (pos. 8) from the towbar
equipment. Choose holes depend on car type.
8
4. Tighten all nuts and bolts according the torque shown in the table.
5. Position the ball of towbar fix with M12x70mm bolts (pos. 4) from the towbar
accessories.
6. Fix the socket plate (pos. 3) as shown on the drawing.
7. Cut the bumper according to figure 2 and mount it to the car.
8. Connect the electric wires according to the instructions of the car.
4
(Recommend to make at authorized service station)
9. Complete the paint cover of towbar (during the mounting paint cover could be
destroyed).
15
Cut for socket
plate
2
car:
Fig. 2 Bumper cut out (top view)
M6 - 11 Nm
M 12 - 87 Nm
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
165mm
25mm
85mm
Axle
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 14 - 138 Nm
NOTE
Lower edge
M 10 - 50 Nm
M16 - 210 Nm