FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
10
5
This towing hitch is designed to assembly in following cars:
MERCEDES SPRINTER 3,55/4,025m, loading platform, single wheels,
produced since 02.1995 till 05.2006,and VOLKSWAGEN LT 28/46,
3,55/4,025m, loading platform, single wheels, produced since 01.1995 till
03.2006, catalogue no. D17 and is prepared to tow trailers max total weight
2800 kg and max vertical load 100 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be installing in points described by a car producer.
10
1
6
3
From manufacturer
5
1. Apply the main bar of the towing hitch (pos. 1) from the
bottom of the car and through fish-plates (pos. 10) fix
using bolts M12x100mm (pos. 5) from the towing hitch
accessories.
2. Fix tow-ball (pos. 2) using bolts M16x50mm (pos. 4)
from accessories.
3. Fix the socket plate (pos. 3) using bolt M10x30mm (pos.
6) as shown on the drawing.
4. Tighten all bolts according to the torque shown in the
table.
5. Connect electric wires of 7-poles socket according to the
2
instruction of the car. (Recommend to make at authorized
service station).
6. Complete paint layer damaged during installation.
4
After install the towing hitch you should get adequate note in
registration book (at authorised service station).The car should
be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball
of towing hitch must be always kept clear and conserve with a
grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M6 - 11 Nm
M8 - 25 Nm
M12 - 87 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm