AUTO-HAK V49 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
1
6
A
10
This towbar is designed to assembly in following car:
NISSAN ALMERA, 3/5 door, (N16), produced since 03.2000 till 12.2006,
catalogue number V49 and is prepared to tow trailers max total weight
1500 kg and max vertical load 75 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
9
5
4
10
9
8
18
2
3
Fig. 1
1. Disassemble the bumper and the muffler.
2. To right chassis member slide bracket (pos. 4) and screw loosely with bolts
M10x35mm (pos. 10) through original holes.
3. Put main part of the towbar (pos. 1) (part A in left chassis member) and screw
loosely with bolts M10x35 and screw all together with mounted bracket (pos.
4) and angle element (pos. 5) with bolts M12x45mm (pos. 9) as shown in the
fig. 1.
4. Angle element (pos. 5) screw with bolt M16x40mm – pos. 7 (instead of
original tow handle).
5. Reassemble the muffler and the bumper (after cut out his fragment) see fig. 2
6. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm (pos. 8)
from accessories.
7
7. Tighten all bolts according to the torque shown in the table.
Original hole
105 115
8. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station).
9.
Complete the paint coating damaged during assembly.
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
The instruction of the assembly
30
35
Original hole
65 75
Fig.2
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
Right side
Edge of the bumper