AUTO-HAK V49A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
6
A
3
9
This towbar is designed to assembly in following car:
NISSAN ALMERA, 3/5 door, (N16), produced since 03.2000 till
12.2006, catalogue number V49A and is prepared to tow trailers max total
weight 1500 kg and max vertical load 75 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
5
4
9
1
Fig. 1
1. Disassemble the bumper and the muffler.
2. To right chassis member slide bracket (pos. 4) and screw loosely with bolts
M10x35mm (pos. 9) through original holes.
3. Put main part of the towbar (pos. 1) (part A in left chassis member) and screw
loosely with bolts M10x35 and screw all together with mounted bracket (pos.
8
4) and angle element (pos. 5) with bolts M12x45mm (pos. 8) as shown in the
fig. 1.
4. Angle element (pos. 5) screw with bolt M16x40mm – pos. 7 (instead of
original tow handle).
5. Reassemble the muffler and the bumper (after cut out his fragment) see fig. 2
6. Fix body of the automat and place tow-ball according to supplied instruction.
Note! Remember to place socket plate (pos. 3) as shown on the drawing 1.
7. Screw all bolts according to the torque shown in the table.
7
Original hole
2
8. Connect electric wires according to the instruction of the car. (Recommend to
make at authorized service station)
9.
Complete the paint coating damaged during assembly.
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
The instruction of the assembly
35
65
105
Fig.2
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
Right side
Original hole
Edge of the bumper