AUTO-HAK P17 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
11
15
G
E
F
7
11
This towbar is designed to assembly in following cars:
CITROEN XANTIA Break, ESTATE (X1/X2) produced since 06.1995
till 03.2001, catalogue no. P17 and is prepared to tow trailers max total
weight 1500 kg and max vertical load 85 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
15
D
12
C
H
1
16
A
11
B
10
A
9
15
3
11
From manufacturer
1. Disassemble the rear bumper and take out spare wheel.
2. Put main bar of the towbar (pos. 1) to rear parto f the car (from inside) and
through holes pos. A fix it by bolts M10x35mm (pos. 11) and big washer
11
(pos. 15) as show on the drawing. Fix loosely.
3. Through holes pos. C fix right arm (pos. 6) using bolts M10x35mm (pos. 11)
next through hole pos. D of element pos. 6 fix to the original holes in the car
using bolts M10x35mm (pos. 11) and big washer (poz. 15), as shown on the
6
drawing.
11
4. Through holes pos. E fix join element (pos. 5) by bolts M12x35mm (pos. 9),
loosely.
5. Through holes pos. F fix elements 5 and 7 as show on the drawing using bolts
M10x35mm (pos. 11) and next through hole pos. G of element 7 fix with
original holes in the car using bolts M10x35mm (pos. 11) and big washer (pos.
15.
6. Fix central bracket pos. 4 through holes pos. B and distance sleeves pos. 16
15
with main bar using bolts M10x50mm (pos. 10). Through hole pos. H fix to
caget nut pos. 12 by bolt M10x35mm (caget nut put into the central chassis
11
member in advance) .
8 7. Tighten all bolts according to the torque shown in the table.
8. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x75mm (pos. 8)
from accessories.
9. Connect electric wires of 7-poles socket according to the instruction of the car.
2
(Recommend to make at authorized service station)
10. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
Fitting instructions
Torque settings for nuts and bolts (8,8):
M8 25 Nm M10 55 Nm
M12 85 Nm M14 135 Nm
NOTE