AUTO-HAK F35 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
C
10
1
A
6
B
16
This towing hitch is designed to assembly in following cars:
PEUGEOT 3008, exept Hybrid, produced since 06.2009, catalogue no.
F35 and is prepared to tow trailers max total weight 1650 kg and max
vertical mass 70 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
4
A
9
16
17
8
7
2
3
11
From manufacturer
1. From the bottom of the car one ought to unscrew three bolts
fastening bumper.
2. In points A (see fig. 1) one ought to unscrew the original bolts.
3. Unscrew fastenings of rear muffler.
4. Bend the heat shield inwards by 10mm (if necessary).
9 5. Apply the main bar of the towing hitch (pos. 1) at points A, B and
5
C.
6. Assembly elements of muffler fastenings with fish-plate (pos. 6).
7. Apply the angle bar (pos. 4) to the right chassis member.
8. Fix loosely flat bar (pos. 5) to the angle bar (pos. 4) and to the
main bar of the towing hitch (pos. 1) using bolts M12x40mm
(pos. 9).
11
9. Fix tow ball (pos. 2) using bolt M12x75mm (pos. 7) and
M12x70mm (pos. 8). With bolt M12x75mm fix also a socket
plate (pos. 3). See figure 1.
10. Tighten all bolts according to the torque shown in the table.
11. Fix bolts fastening bumper again.
12. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized service
station).
13. Complete paint layer damaged during installation.
Fig. 1
M6 - 11 Nm
M 12 - 87 Nm
After install the towing hitch you should get adequate note in registration
book (at authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be
always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 14 - 138 Nm
NOTE
M 10 - 50 Nm
M16 - 210 Nm