AUTO-HAK C002 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
8
4
5
5
This towbar is designed to assembly in following cars:
FORD FIESTA, 3/5 doors, except Sport, produced since 01.1996 till
04.2002 and MAZDA 121, 3/5 doors (JASM/JBSM), produced since
03.1996 till 08.1999, catalogue no. C002 and is prepared to tow trailers
max total weight 950 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
8
5
1
7
6
3
From manufacturer
1. Take the spare wheel out the bumper.
2. Find original metal covers on the left and right sight (inside the
trunk), remove it, then you will see holes towards the chassis
members.
4
3. Put the distance sleeves L=50mm (pos. 5) there and position the fish-
plates (pos. 4) and bolts M10x80mm (pos. 8) - see the fig.
5
4. Position the main bar of the towbar (pos. 1) at the bottom of the car
and then fix it.
5. Position the ball of towbar (pos. 2) with socket plate (pos. 3) and fix
with bolts M12x75mm (pos. 6) and M12x70mm (pos. 7) from the
towbar accessories.
6. Tighten all nuts and bolts according to the torque shown in the table.
7. Connect to the electric wires according to the instructions of the car.
8. Complete the paint cover of towbar (during the mounting paint cover
15
could be destroyed).
2
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm