Fitting Instructions - AUTO-HAK C43 Instructions De Montage

FITTING INSTRUCTION
6
1
3
12
2
This towing hitch is designed to assembly in following car:
FORD FUSION produced since 2002 , catalogue no. C43 and is prepared
to tow trailers max total weight 900 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
4
5
From manufacturer
1. Disassemble the bumper.
2. Slip main part of the towing hitch (pos. 1) to chassis members
and fix it with bolts M10x40mm (pos. 6) from accessories (use
flat washers – pos. 4).
3. Assemble the bumper.
4. Fix the tow-ball (pos. 2) and socket plate (pos. 3) using bolts
M12x75mm (pos. 5) from accessories.
5. Fix all bolts according to the torque shown in the table.
6. Connect electric wires according to the instruction of the car.
(Recommend to make at authorized service station)
7. Supplement the paint coating damaged during assembly.
6
M 8
M 12 85 Nm
After install the towing hitch you should get adequate note in registration
book (at authorised service station).The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts. The ball of towing hitch must be always kept
clear and conserve with a grease.

Fitting instructions

Torque settings for nuts and bolts (8,8):
25 Nm M 10 55 Nm
M 14 135 Nm
NOTE