Installation; Dmx512 Use - Starway ParKolor 200HD Manuel De L'utilisateur

Installation

Setup :
The projector can be mounted in any position and at any angle.
When placed, the surface supporting it must be able to withstand at least 10 times the weight of the projector and must
be stable enough not to cause damage to the projector, people or surrounding objects.
When the projector is hung, systematically and obligatorily remember to secure it with a safety chain.
Electrical connection :
Under 230 VAC, 10 ParKolor 200HD can be connected with the IN and Out connectors.
Under 110 VAC, 5 ParKolor 200HD can be connected with the IN and Out connectors.

DMX512 use

The use of a DMX amplifier is necessary if you use more than 20 interconnected units or a line longer than 60 m.
The use of a real DMX cable (120 ohms) makes it possible to avoid untimely loss of information. The use of a terminal
plug is strongly recommended. In some cases, the absence of this termination is not a problem. On the other hand, its
presence is very strongly recommended in disturbed spaces (Stage, long line length, TV studio, etc.). Its value is usually
120 Ohms. The cap is a male XLR socket in which is soldered, a resistance of 120 Ohms ¼ of W, between the pins
2 and 3 of the XLRs.
The cap prevents the reflection of transmitted information when using long cable lengths.
2 1
3
5
1
4 2
3
GND
DATA +
DATA -
GND
DATA -
DATA +
NON CONNECTE
NON CONNECTE
1 2
3
1 2
3
120
5
1
2 4
3 5
1
2 4
3
Ω
120
Ω
Page 25