Informations - Ramiaudio AMC610 Manuel Utilisateur

REAR PANEL
Sending an order signal instantly fades the modulation in the headphones.
The order signal routing can be set up via hardware jumpers (internal): either directly to headphone 1
or to all headphones
Order Signal Routing Set-up
As default, the AMC610 is configured with jumpers in position A
INFORMATION
Warning
AMC610 mains connector has three wires (2 poles + earth). Earth should imperatively be connected to mains
earth.
Never use this equipement without proper grounding.

Check quality of grounding.

Should noise or hum occurs when connected to other equipments, never disconnect grounding, use insulating

transformer on mains.
Never open the case without disconnecting mains

Avoid high temperature exposure.

Never expose the equipment to rain, snow or moisture.

Using AMC610 headphone amplifier, listening to high level can result in permanent damage to ears.

AMC 610 complies with :
EN60065, EN55013, EN55020, EN60555-2, and EN60555-3, according to 73/23/EEC, 89/336/EEC et 93/68/EEC.
Rami
JP 1 and JP 2
POSITION A :
Order signal sent with fade in
headphones 1 to 6.
POSITION B :
Order signal sent with fade only
to headphone 1.
13
Next
AMC610