Ramiaudio AUF300 Manuel Utilisateur page 22

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FRONT PANEL
CHANNEL C
12
12 -
Multi-turn cermet potentiometer for the sensitivity calibration on left or right level of C
channel
Variable from + 12 dBu to - 10 dBu. The sensitivity (gain of input level ) increases clockwise
13 -
Multi-turn cermet potentiometer for VCA rising time calibration of channel C ( fade in time
from 0 to 100% of the audio modulation ). Variable from 0 to 4 seconds. The time increases
clockwise.
14 -
Multi-turn cermet potentiometer for VCA falling time calibration of channel A (fade out time
from 0 to 100% of the audio modulation ). Variable from 0 to 4 seconds. The time increases
clockwise.
15 -
Multi-turn cermet potentiometer for the delay calibration during the transition of channel C to
channel A or B , after detection of signal absence on the channel C. Variable from 0 to 8
seconds. The time increases clockwise.
Note : this regulation must be rather short time in order to avoid a too long blank at the end of
the message on the channel C, but not so long in order to avoid inopportune rising up of
channel B or A (during the short audio modulation blank on the channel B or A).
This multi-turn potentiometer (9) is only active in auto or auto + manual mode.
16 -
Multi-turn cermet potentiometer for the modulation detection threshold calibration of C
channel. Variable from - 6 dBu to -36 dBu. The sensitivity (gain of detection level) increases
clockwise. This calibration must be done after the input sensitivity (12).
Note : it must be rather sensitive in order to detect the low levels of the modulation, but not so
much to avoid triggering on the hissnoises or on the line interferences .This calibration is
rather crucial and particularly interesting on a connection with bad S/N ratio.
This multi-turn potentiometer (10) is only active in auto or auto + manual mode.
17 -
Warning light indicating that channel C is open (audio proceeding).
RAmi
13 14
15 16 17
The C channel is attributed to the replacement
modulation.
(Advertisement, jingle, identification, priority
message ).
22
Next
AUF 300

Publicité

Chapitres

Table des Matières
loading

Table des Matières