Overview Of The Control Panel - Samsung DV476 Serie Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

operating instructions, tips
To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFTY
INSTRUCTION before operating this appliance.
WARNING

OVERVIEW OF THE CONTROL PANEL

1
2
Digital Graphic
1
Display
Select Cycle
2
Option
24_ operating instructions, tips
DVDV476_484_03022E-03_EN.indd 24
DVDV476_484_03022E-03_EN.indd 24
3
The display window shows the estimated time remaining in the cycle after you
have pressed the Start/Pause button. The estimated time remaining may fl
uctuate as the cycle progresses.
The Drying light will illuminate and remain lit until the cycle is complete.
When your dryer is in the cool-down phase, the Cooling light will illuminate. When
your dryer is in the wrinkle prevent phase, the Wrinkle Prevent light will illuminate.
When the cycle is complete, "END" will appear in the display panel until you
push the Start/Pause button or the Power button. If your dryer is paused during
a cycle, the indicator lights will blink until you press the Start/Pause button.
Adjust Time – You can add or subtract time from the automatically set times
in the Wrinkle Away cycle and the Manual Dry cycles (Time Dry, Quick Dry, or
Air Fluff cycles.)
To add or subtract time from the cycle, press the Adjust Time arrow pad up
or down until the desired time is displayed.
Wrinkle Prevent -Wrinkle Prevent provides approximately 180 minutes
of intermittent tumbling in unheated air at the end of the cycle to reduce
wrinkling. Press the Wrinkle Prevent button to activate this feature.
The indicator light above the pad will illuminate when you select Wrinkle Prevent.
The load is dry and you can remove it at any time during the Wrinkle Prevent cycle.
Rack Dry – Rack Dry is available at Time Dry cycle. Temperature will be set
only to Extra Low. (See page 28 for detail.)
Mixed Load Bell - The mixed load bell that notifi es you when the average
dry level in a load is damp dry (80 % dried). This lets you take garments that
you don't want fully dried or that dry quickly out of the dryer early while letting
others continue to dry.
You can select this function in all Sensor Dry cycles except Wool and Sanitize.
The dry level selections are limited to Normal Dry, More Dry, and Very Dry.
Signal – When the cycle is complete, a chime will sound.
When you select the Wrinkle Prevent option, the chime will sound intermittently.
Adjust the volume of the chime or turn it off by pressing the Signal button.
Press the button repeatedly to scroll through the choices.
4
5
6
7
2013-06-28
2013-06-28
8
7:24:34
7:24:34

Publicité

Table des Matières
loading

Table des Matières