Fermax 5293 Manuel D'installation page 7

Cod. 970030 V04_18
Change master code
Add or remove users
Add users
* (Master) #
1 (read card or cards or PIN (4-6 digits)) #
*
Add users by assigning the identifier User ID (ID 1-598) and remove users with a specific ID.
ID Usuario, cualquier número entre 1 a 598. Remember not to add zeros to the left of the ID number.
Add users with a specific ID
* (Master) #
1 (user ID)# (read card or PIN (4-6 digits)) #
*
Add users with a panic ID (599 or 600) and
Panic users open a door and activate the auxiliary exit Alarm for 1 minute or until a valid card or pin are presented.
Add users with a PANIC ID
* (Master) #
1 (599 / 600) # (read card or PIN (4-6 digits) #
*
Change Door Opening Time.
Exit relay time
* (Master) #
3 (1-99) # (1-99sec.)
3 0 # (ON/OFF)
*
Add users with card+PIN Add 1º cards 2º change the PIN assigned by default
1º Adding users
* (Master) #
1 (read card or cards) #
*
By default all cards are assigned the code 8888.
Change access mode
Cambio / Change / Veränderung / Mudança Master (123456)
* (123456) #
0 (new master code 6 digits) # (repeat new master code 6 digits) #
*
Remove users
* (Master) #
2 (read card or cards or PIN (4-6 digits)) #
*
2º Change PIN with valid card or with User ID.
* (read card) (current PIN 8888) # (new PIN) # (repeat new PIN) #
* (user ID) (current PIN 8888) # (new PIN) # (repeat new PIN) #
*
Remove users with a specific
ID
* (Master) #
2 (User ID) #
*
Delete all users
* (Master) #
2 (Master) #
*
7
remove all users.