Part Of The Reason For Not Working - OSCAR OS22 Manuel

9.Continuous heating of indoor air mode in solar
10.Continuous heating of indoor air mode in power use: No

Part of the reason for not working:

⚫ The temperature and humidity display, or the operation of the fan and automatic air vent
will have some lag. Within 10-30 minutes, the work will start when stable Sunshine is
detected. It is recommended to check again after half an hour. The program will run
automatically. This is not a quality issue.
⚫ The correct clock must be set for the collector to work normally. To set the clock, press
the SET and M buttons at the same time for more than 2 seconds.
⚫ The human body can interfere with the analog signal. When testing the air outlet, please do not
hold it with your hands.
⚫ Avoid placing the photoelectric switch of the air outlet directly at sunlight or incandescent lamps
light. Please install the photoelectric switch facing down to avoid possible sunlight.
⚫ Some power adapters may have unstable voltage, interruption or black screen in DC mode, etc.
Please replace the power adapter.
⚫ If you feel that the automatic air vent is noisy, please plug in the power to reduce the number of
operations. Reduce the use of automatic mode.
⚫ To obtain reasonable moisture, cold air may enter the room or sometimes prevent heating in
the sun.
⚫ Whether the indoor and outdoor sensors can be connected and displayed normally, and
whether the installation location is reasonable.
⚫ The yellow and red wires are connected in series to test whether the fan can run.
⚫ The warranty period is 2 years from the date of purchase.
After disposal, please dispose of this product in an environmentally friendly manner:
The device complies with the European ROHS guideline 2011 / 65 / EU on the use of certain
hazardous substances in electrical and electronic equipment.
：
Ventilation start time, the default is 4 am;
： Ventilation stop time, the default is 20 pm.
是否要放到前面去
11