Gardco PowerForm Instructions D'installation

INSTALLATION INSTRUCTIONS
PowerForm Flood—Glare Shield Installation (PFF-GS)
IMPORTANT: FOR YOUR PROTECTION, YOU MUST CAREFULLY READ ALL WARNINGS AND INSTRUCTIONS IN THEIR ENTIRETY PRIOR TO
INSTALLATION, OPERATION, SERVICE OR MAINTENANCE. FAILURE TO DO SO CAN RESULT IN DEATH, PERSONAL INJURY AND PROPERTY DAMAGE. If
you do not understand these warnings and instructions, or if additional information is desired, please contact Signify at
SanMarcos.TSC@signify.com
(4) #10-24 screws
Fig. 5
© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio
of Signify which information may be subject to change. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for any action in reliance thereon is
disclaimed. The information presented in this document is not intended as any commercial offer and does not
form part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.
Page 1 of 1 P/N 443560815490 Rev. C
phone 800-227-0758.
Glare Shield Installation Instructions
The quantity of Glare
Shields depends on the
number of LED modules,
one shield per module.
Fig. 1
Fig. 3
1. Locate the notch on the Glare Shield. (Fig. 1)
2. Place notch side on connector side. (Fig. 2)
3. Place Glare Shield on top of optics as shown. (Figures 3 & 4)
4. Secure Glare Shield with (4) #10-24 screws (supplied) into
Notch
Connector side
heat sink channels as shown. Tighten to approximately
15 in-lbs. (Fig. 5).
Signify North America Corporation
200 Franklin Square Drive
Somerset N.J. 08873, USA
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Fig. 4
Notch side
Fig. 2
www.gardcolighting.com